隨著濟南房地產的發展₪☁✘，近期電纜橋架的需求真是直線上升₪☁✘，那麼在進行電纜橋架的整體施工建設當中₪☁✘，需要注意什麼₪☁✘，才能保障工程進度₪☁╃•。

　　With the development of real estate in Jinan, the demand for cable tray has really risen in a straight line in the near future. So what should be paid attention to in the overall construction of cable tray to ensure the progress of the project.

　　電纜橋架裝置負載支撐點間隔不應超過容許負載和支撐跨度₪☁╃•。挑選電纜橋架總寬時要留出一定的預留位置₪☁✘，便於為日後增加電纜線用₪☁╃•。當電線電纜和變頻電纜較較少時,可同一電纜橋架組裝,但正中間得用擋板將電線電纜和變頻電纜分隔鋪設₪☁╃•。

　　The spacing of load support points of cable tray device shall not exceed the allowable load and support span. When selecting the total width of cable tray, a certain reserved position shall be reserved for the convenience of adding cables in the future. When there are few wires and cables and frequency conversion cables, they can be assembled on the same cable tray, but the wires and cables and frequency conversion cables must be separated by baffles in the middle.

　　電纜橋架水準鋪設時₪☁✘，橋架的連線頭應儘可能設在跨度的1/4上下處,水準方向的電纜線每過2米長固定不動一下₪☁✘，豎直方向的電纜線每過1.5米長固定不動一下₪☁╃•。電纜橋架的選擇常見注意事項₪☁╃•。

　　When the cable tray is laid horizontally, the connector of the bridge should be set up at the top and bottom of 1/4 of the span as far as possible. The cable in the horizontal direction should be fixed every 2 meters, and the cable in the vertical direction should be fixed every 1.5 meters. Common precautions for selection of cable tray.

　　電纜橋架裝置除需遮蔽掉裝防護罩外₪☁✘，在戶外組裝時要則在高層改裝防護罩₪☁✘，避免日曬日曬雨淋₪☁✘，對如果需要電焊焊接安裝中₪☁✘，焊接件四周的焊縫厚度應不小於原材質厚度₪☁✘，焊縫要進行防鏽處理₪☁╃•。

　　In addition to shielding off and installing protective covers for cable tray equipment, the protective covers shall be refitted at the high level during outdoor assembly to avoid exposure to the sun and rain. If electric welding is required for installation, the weld thickness around the weldment shall not be less than the thickness of the original material, and the weld shall be subject to rust prevention treatment.

　　總的來說₪☁✘，電纜橋架在鋪設搭建時₪☁✘，都需要嚴格執行₪☁✘，防止發生意外₪☁╃•。如果你正在尋找電纜橋架廠家的話₪☁✘，不妨來我們蘇鑫瞭解一下吧₪☁✘，附帶安裝哦₪☁╃•。

相關文章·•◕：濟南電纜橋架